Fixing Error Code 228 on Your Lennox® Furnace

Not getting heat and receiving error code 228 from your Lennox® furnace?

This means your furnace couldn’t correct its pressure switch before turning on. As a reaction, your system will not run for your protection.

Repairing or replacing this part is best left to the professionals at Roy Inch & Sons Service Experts Heating & Air Conditioning in London. Our NATE-certified technicians are among the elite in the industry. They’re well-prepared to take care of all of your heating needs, including fixing a furnace error.

We want you to be thoroughly satisfied with our quality furnace repair in London. That’s why we back it with a 100% Satisfaction Guarantee* for a year.

How a Pressure Switch Works

This part plays a prominent duty as your furnace prepares to heat your home.

Here’s what happens after your thermostat’s call for heat:

  • Your furnace’s control board starts running the draft inducer blower motor. This pushes out combustion gases from the heat exchanger and brings in new gas and air so the burners can fire.
  • When the pressure switch senses that enough air is being pulled into the burners, it closes and signals the control board to ignite the furnace.
  • Your furnace ignites and creates heat.

What Happens When a Pressure Switch Breaks Down

When your pressure switch isn’t operating promptly, you’ll likely hear the fan going and the switch clicking a few times before the furnace turns off completely. When a part isn’t working right, your furnace will turn off to protect you.

Your furnace will let you know something is amiss with a red flash from its indicator light, which it uses to exhibit error codes. It uses this red light to flash code, like Morse code.

You may note short flashes or an alternating slow flash as it passes on a fault code.

Estimated Repair Cost for Furnace Error Code 228

Before replacing the switch, your Roy Inch & Sons Service Experts Heating & Air Conditioning Expert will check other parts of your furnace first. Some other issues can also cause the error code, like a congested vent or cracked hose.

The cost to remedy your furnace depends on the issue with it and how long it takes to fix it.

If your pressure switch needs to be replaced, you can plan to pay between $40 to $350.

Count on the Experts at Roy Inch & Sons Service Experts Heating & Air Conditioning

If you need furnace repair, trust the technicians from Roy Inch & Sons Service Experts Heating & Air Conditioning to understand the fault code and fix the problem to your standards.

Call us at 226-270-1164 or schedule an appointment online today.